Page 1 of 1

Canon Battery Grip with 1 Battery?

PostPosted: Fri Apr 09, 2010 7:22 pm
by ks04
Hi Guys,
Noobie question for you all - looking at getting a Canon BG-E2 for my 30D which gives the ability to use 2 batteries in, however can i use the grip with just a single genuine canon battery?
Cheers.

Re: Canon Battery Grip with 1 Battery?

PostPosted: Fri Apr 09, 2010 7:40 pm
by DaveB
Sure can!

But if you can, do get the BG-E2N. There were many BG-E2s with faults, so I'd be careful if you're looking at the 2nd-hand market.

Re: Canon Battery Grip with 1 Battery?

PostPosted: Fri Apr 09, 2010 7:49 pm
by ks04
Brilliant! thankyou!
What sort of faults did they have? first i've heard of it

Re: Canon Battery Grip with 1 Battery?

PostPosted: Sat Apr 10, 2010 12:07 am
by DaveB
With mine (on a 20D) I had two issues:
  1. In "portrait" orientation with a heavy lens on, there was enough flex in the body that occasionally the microswitch that normally provides the "battery door closed" signal was no longer being pushed in by the battery grip, and the camera instantaneously turned off.
  2. The power would be reported as low too soon. By removing the grip and putting the same battery in the body, the power was reported as full.
Neither of these issues had ever occurred with the grip on my earlier D30 and 10D bodies, and Canon agreed it should not have happened here. After an unsuccessful replacement I gave up on the grip. As it happened I was happier with a lighter rig (although there are times the grip would be nice).

Canon did say they fixed these issues, but I'm sure there are plenty of busted ones floating around still. It wasn't just me: there was lots of fuss about this grip all over the web at the time. I've only heard good things about the BG-E2N though.